Search results

If the belt slips I would try another style belt.Does the belt fit the pulley correctly?

There’s three holes 1 3/4inch in diameter the one for plug one in rear used 1 1/2 drum sander to cut the exhaust cut out I’m good my scratch built rigger has the same cowl and holes runs fine no issues with what your saying

Was thinking I cleared 5 boats a gas whip 20 whip warlock and two sling shots from the quart of clear very cost effective.I started using the Pyrex mixing cup after I went to buy the small graduated mixing cups and they were out.So I bought the glass measuring cup and use the Laquer thinner to...

Make sure you buy some lacquer thinner I buy the sunny side brand from Menards for cleaning I also have a respirator for isocynades my compressor I have a water trap on the regulator

There’s enough have the hole for plug and there’s a hole in the rear plus pipe cut out

The last quart I painted 4 boats Im using a touch up gun I mix between 4 to 6 oz at a time.I run it @50 psi as there’s 50 foot of hose .I used my small compressor once but took for ever to build that was when I was camping back at home I have a 2 stage 80 gallon tank puts out 15 cfm it’s a 175...

I painted it the same as my whiplash.

Painted this weekend the cowl had lots of dust so I wet sanded it and cleared it turned a lot real nice.Mounted all the hardware took some pictures realized I forgot the turn fin.The holes for pushrods worked well with my cross brace servo mounts.

I have the cmb 27 in mine any recommendations

I appreciate the help just trying to figure out some props for my new builds.What props do the f41 cats like if you have any experience with them.

Bob so which ones are low lift number wise

Need to get a few more props not sure which ones are low lift pusher style props or lifting style props.I do know the chopper ones work well on monos.I need to get some for a f41 cat and some for a slingshot rigger.My question is how does the rake and bar numbers work?

I heat the garage then I paint it out side as soon as it’s painted I bring it in where’s it’s warm I like 50 or more degrees

I’m curious also weather has changed all the 2 foot of snow is mostly gone.Im hoping to paint the kit slingshot Saturday.

Got a good deal on this hull so I pulled the cmb 27 out of the 44 inch stock seaducer was too much engine for that hull.I used zipkitts hardware and radio box.Used the same homemade engine mounts and gizmo pipe.Bought the Sullivan tank with screw on lid fits in the hull.I got the hull from Rick...

The header is a 2 inch offset 7/8 header also cross posted

New flange used 2 inch offset 90 header new traxxas push rod seals with mounts new gas starter belt 35.00 plus shipping

F em If you can F em if you can’t that way your covered.

I would turn the servo around so the linkage is straight back not on a angle.

Buy some tig rod and thread it I find pieces on lifts from off rent I grab them up stainless 1/16 1/8 and 3/16 sometimes I get lucky find full pieces.Certain renters I can just ask for a few pieces