Search results

I got the X 450/3's really need at least a 1457 b9ut also looking for a 1460.

I need help pretty quick, I need a 1457, a 1460 and an X450/3 ready to go

Mike and Mr. Kirbitz, Mike I received a nice envelope from you that has a nice hole thru it. You guessed it,there was no rod. You need to use a bubble wrap envelope or at least tape it to a piece of heavy paper. There is no rod for you Mr. Kirbitz. Tom Galdys

As you all may know, I build and run OPS 45's 67's and 80''s. Yes there is a problem with thecarbs loosening up and JB weld is the way to go. As far as the rods go, they really don't need to be bushed at the top as they don't spin. There is not much movement inside the piston. As far as the...

I'll take the titanium rod for the OPS67

Al, If that header would fit the K45, I'll take it if it is still available. Thanks Tom

It is the rod. When you flipped it was still spinning and the water would not compress. This distorted at least the rod and possibly the piston around the wrist pin cogs.

I agree this guy is a real piece of shart. I do have a question tho, what is OSE?

Just got 3 brand new Kalistrakov K45 motors. They are awfully good looking and feeling engines. Time to put in my 45 rigger. Any recommendations? Tom

His email is [email protected] Tom

Yes sir, all new. Tom Galdys

Dan, I have all you need for 120.00 shipped in lower 48. Tom Galdys

Hey Bob, If it's 3.5 stuff just come on over.

Walt, I have new,used and RPM rods available. Tell me what you need. Tom

I have a NIP RPM rod for OPS45, for 50.00 shipped and I also have OPS 67 rods non RPM 40.00 each. I also have OPS 45 rods for 25.00 each

Ed, I do have some new and used that I was going to put into the cases I'm looking for. For a fellow boater, I can get you a new piston and sleeve for 80.00 shipped. I have a new RPM rod also for 50.00. Tom

Dave, Send me a list, I can help you out with everything but the slide carbs. I have plenty of Aeromarine and other carbs though. Tom

Anyone have any thoughts on the K45 engine? Front exhaust? Rear exhaust? Thanks Tom Galdys

Brad, I have a total of 15 rods, 9 bushed at both ends, 6 needle bearing, needle bearing crank all new and all OPS. I'll do an even up trade if ok with you. Tom

I think you gentlemen are invaluable to our hobby. Thank you. I have learned much. Tom