Search results

Try Hobby Supplies in Australia, they have the CMB 21 Valvola listed. http://www.hobbysupplies.com.au/CMB%20Engines.HTM Eddy.

Viper40 I was told by Hobby Supplies the latest 45 CAM 2004 engines they stock have a new liner with different port angles that give higher RPM and better plug life. I'm not sure if the Tidewater engines have this liner. Ed.

Brian. From what i've been told its a combination of two problems. One/ The 45 CAM 2004 engines from Tidewater have crap bearings fitted that get excessive clearance after only a few runs causing the crank and rod to rub on the case in different places. Two/ The Tidewater 45 CAM engines...

Kris, Spoke to Hobby Supplies in melbourne yesterday and they have a second hand JR R1 PCM 36 radio for sale $495.00. They told me the radio is the new limited gold series as new two months old in the box with PCM receiver transmitter nicad pack and 240v charger. Wish i had the money on hand...

Try Alan Hobbs in the US on e-mail: [email protected] , he will be able to help you.

Twin K90 / Anders. I've run 18%, then 20%, then 22% and in desperation 25% Caster/Klotz blend and still K90 problems. Also tried top cooling only and a mod head button and still the same, Bang !!!. :o 4 P/S, 2 Wrist Pins and 2 Rods later I gave up and I'm not the only one that's had these...

Twin K90. I wouldn't like to run more than 25% oil as this is what I ran last time the K90 engine blew. You shouldn't need to run that much oil, 25% is over the top. ED.

Nitrocrazed, One sided BS is a bit hard to take after a while and needs to be explianed or corrected. ED

Twin K90. Yes I have seen looked inside my K90 and they are as well machined as the CMB/MAC. Infact I often needed to look inside my K90 to repair the stuck P/L's, broken wrist pin's, rod's etc. As I said, one race win here or there. How did your X-Hydro place at other race meetings down...

Between the A and the K motors they are the 2 finest made motors in the world! Leaves the CMB/Picco/Mac FOR dead ---------------------------------------------------------------- Twin K90. Come on, a race win here or there doesn't mean the leave CMB/PICCO/MAC for Dead. BS ??? CMB, Picco...

Mark, I've been running a 60/80 Hummingbird with a green head CMB 67 for the past few months and they are very fast and handle like their on rails ;D. The setup instructions are good and Jim strongly recommends to use Speedmaster hardware as the measurements are correct for his setup. I...