What's everyone working on for 2016

Bradley Maglinger · May 5, 2016

Scott PM sent

SayMikey · Jun 14, 2016

New for 2016 sport 40 assembly time

stuart cortis · Jun 16, 2016

My Dr Toyota

soon full restoration

stuart cortis · Jun 16, 2016

My Dr Toyota

soon full restoration

scott williamson · Jun 21, 2016

53 inch gas powered mono

scott williamson · Jun 21, 2016

Should have posted this instead being a hydro forum. 1/6 scale.

scott williamson · Jun 21, 2016

Should have posted this instead being a hydro forum. 1/6 scale.

wayne middlemiss · Jun 21, 2016

scott williamson said:
Should have posted this instead being a hydro forum. 1/6 scale.

You have been busy

David Ashcroft · Jun 22, 2016

Scott is that a going to be a Miss excide?looks good thus far

.

wayne middlemiss · Jun 22, 2016

David Ashcroft said:
Scott is that a going to be a Miss excide?looks good thus far

.

Aussie endeavour

David Ashcroft · Jun 22, 2016

Great even better ..

scott williamson · Jun 22, 2016

Thanks David ,as Wayne said it is Aussie Endeavour. Here's another one im building. 1/6 scale inline twin paynpak.

Hydro Junkie · Jun 22, 2016

Scott, what are you using for an engine in that Pak? I'm presently redrawing a set of Newton 108 plans into a gas scale 78 Madison. I'm looking at a CMB 27 for an engine in it due to the size of the engine bay so your twin has me curious

P THOMAS · Jun 22, 2016

Finishing up my gas scale Miss US

Tim Strange · Jun 22, 2016

Looks good Phil!

Your driver looks quite happy that you got those blue stripes laid out!!!

Ray Sametz · Jun 22, 2016

Finally getting back to my M/L Sport 40, hope to have ready for Hobart. Working on radio box layout with Micro servos, it's tight. Steering servo will be a Savox waterproof. Everything is a figure as you go with this engine placement.

DeanJohnson · Jun 22, 2016

Hi Ray,

Who makes that motor mount? I'm in the process of building this hull right now - did you reinforce the floor under the mounts?

scott williamson · Jun 22, 2016

Hydro Junkie said:
Scott, what are you using for an engine in that Pak? I'm presently redrawing a set of Newton 108 plans into a gas scale 78 Madison. I'm looking at a CMB 27 for an engine in it due to the size of the engine bay so your twin has me curious

Gday Mark , im using an RCMK bottom end with modified zenoah cylinders.

Ray Sametz · Jun 22, 2016

Hyperhydro said:
Hi Ray,

Who makes that motor mount? I'm in the process of building this hull right now - did you reinforce the floor under the mounts?

Motor mount is Speedmaster with reversed 2' alum. angle. Reinforced the floor from under side of boat.

What's everyone working on for 2016

Help Support Intlwaters:

Well-Known Member

Well-Known Member

New Member

New Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Similar threads

Join the conversation!

Join today and get all the highlights of this community direct to your inbox. It's FREE!