were do i measure to on pipe to cut
- Thread starter ww29
- Start date
Help Support Intlwaters:
Chris Wood
Well-Known Member
- Joined
- Jan 4, 2002
- Messages
- 3,494
not super critical. i would try to measure to the seam. hard to see the pipe in the pic as it is HUGE.
the key is use the same spot ALL THE TIME. dont deveate from that and you will be fine
chris
the key is use the same spot ALL THE TIME. dont deveate from that and you will be fine
chris
William take two Inches off that header and it will run
Better. I figure 5" for the center of engine to the end
Of the header. If you keep your header like mine you
Can measure off the water fitting on the left side of
The water jacket. Pipe should be around 2.5" to 3" this way.
Have Fun Testing
Mark Sholund
Better. I figure 5" for the center of engine to the end
Of the header. If you keep your header like mine you
Can measure off the water fitting on the left side of
The water jacket. Pipe should be around 2.5" to 3" this way.
Have Fun Testing
Mark Sholund
Last edited by a moderator:
RodneyPierce
Well-Known Member
- Joined
- Mar 26, 2006
- Messages
- 4,464
The best stuff there is IMHO. Cant beat Tim's products or service
