Wanting to see bottom of 85' Miller American Hull 8401

[Kevin Lloyd]

I'm building an 85' Miller American off of Newton/Ml Boatworks laser cut kit and would like to see a picture of the bottom of hull, specifically the belly pan. This boat didn't have rear shoes like the 88-89 Circus, but I'm curious as to how far back the belly pan runs.

Thanks for any and all pictures. The 88 Miller High Life would have the same belly pan.

Thanks, Kevin

 

[Lennard Cuenco]

kevin

have u checked david newtons site? there are several photos of these boats in a sling

 

[Kevin Lloyd]

i will check again, sometimes it's hard to get an accurate idea from the full sized boats

 

[Hydro Junkie]

Here you go http://newtonmarine.smugmug.com/Hydroplanes/1985/10714200_dVjYx#!i=746262735&k=y8g7k

 

[Kevin Lloyd]

Thanks, have that pic, was hoping to see an actual model pic, I will get in touch with Don.

 

[Mike McKnight]

Kevin did you get the one I sent you?

 

[Kevin Lloyd]

Mike, Yes I did, thank you for that. Hard to tell where the pan ends. Can you measure from pan end to transom for me.

Thanks, Kevin

 

[Hydro Junkie]

Looks to me like the pan ends at the bottom break on the full sized boat. It also looks to be about 4" deep and blends into the rear bottom like the 8806 hull that I've checked out personnally

 

[Kevin Lloyd]

Makes sense, thank you.

 

[Mike McKnight]

Kevin mine blends to flat at 4.75" before the transom

 

[Kevin Lloyd]

thanks Mike