tide water .90 engine mounts 5" complete

[camaroboy383]

have a .90 tide water engine mount set...5".... look new just been around for a while...rubber mounts look great... comes with bolts,nuts and washers for mounting to the boat...$35.00 shipped anywhere in the lower 48 states...

 

[Tall Fella]

Hello Alden .

This is a enquiry from Australia . I have contacted you in the past about a OPS 67 parts lot and missed out . This mount you have listed now , is is made for a OPS 67 or OPS 90 by chance . If so , I am very interested . I look forward to your reply .

Regards

Ian Baas

Tall Fella Racing

 

[camaroboy383]

Hello Alden .This is a enquiry from Australia . I have contacted you in the past about a OPS 67 parts lot and missed out . This mount you have listed now , is is made for a OPS 67 or OPS 90 by chance . If so , I am very interested . I look forward to your reply .

Regards

Ian Baas

Tall Fella Racing

Hi ian, good to hear from you again. If you could measure the distance between the holes in your engines, i can give you a yes or no.guess you could always drill and tap a new pattern into the mount. Let me know a measurement and ill let you know. Good to hear from you, hope all is well.

Alden

 

[Tall Fella]

Hello Alden .

All dimenions are in mm .

For the OPS 67 -

The width of the case is ~ 43.09

The depth of the case is ~ 22.5

The c / l width across for the bolt holes is 51

The c / l distance along the mounting flanges are 20

For the OPS 90 -

The width of the case is ~ 60.3

The depth of the case is ~ 32

The c / l width across the bolt holes is 70

The c / l distance along the mounting flange is 30

I am used to using Octura mounts and have a post on the AMPBA Forum ( Australia ) and have not had any responses as yet . I look forward to hearing back from you . Its possible that I might still be in your address book from our previous discussions / enquiries . Thanks for your comments and be sure to keep well as well .

Regards

Ian Baas

Tall Fella Racing

 

[camaroboy383]

Hello Alden .All dimenions are in mm .

For the OPS 67 -

The width of the case is ~ 43.09

The depth of the case is ~ 22.5

The c / l width across for the bolt holes is 51

The c / l distance along the mounting flanges are 20

For the OPS 90 -

The width of the case is ~ 60.3

The depth of the case is ~ 32

The c / l width across the bolt holes is 70

The c / l distance along the mounting flange is 30

I am used to using Octura mounts and have a post on the AMPBA Forum ( Australia ) and have not had any responses as yet . I look forward to hearing back from you . Its possible that I might still be in your address book from our previous discussions / enquiries . Thanks for your comments and be sure to keep well as well .

Regards

Ian Baas

Tall Fella Racing

ian your ops 90 will bolt right into this tidewater mount...i did the conversion and it is right on...let me know if you want it...

alden

 

[Tall Fella]

Hello Alden .

This all sounds like it will do the job . Can you send me a private message with your e - mail address and we will talk some more about it . And possibly incude a picture later on in your e - mail . Thanks again .

Regards

Ian Baas

Tall Fella Racing