- Joined
- Sep 4, 2007
- Messages
- 3,714
i purchased a new speedmaster rudder assy. for this boat do i need to shorten the rudder or keep it the stock length
why was this deleted?DELETE
I imagine you will end up cutting an inch off but run it full length first. If the boat is too tight cut a little at a time off but not more than an inchwhy was this deleted?DELETE
ok thanks mikeI imagine you will end up cutting an inch off but run it full length first. If the boat is too tight cut a little at a time off but not more than an inchwhy was this deleted?DELETE
Your there should be a good prop start the pipe at 11 1/2i was also going to start with an octura x457 3 blade prop its a pre exr picco .67 with mods done to it any input would be helpfull
What is the Elevation in Vegas?i was also going to start with an octura x457 3 blade prop its a pre exr picco .67 with mods done to it any input would be helpfull
2000 feetWhat is the Elevation in Vegas?i was also going to start with an octura x457 3 blade prop its a pre exr picco .67 with mods done to it any input would be helpfull
Just wondererd, Thought Vegas was higher in elevation. I moved from Sacto. Ca. (77 ft elev. To Ogden, Ut. 4,500 ft. elev.) What worked well in Sac. (x457/2) would get the boat up on plane immediatly/w 20% nitro. Made a lot of changes to the boat That I thought were for the better. But it fell flat on its face w/ a x-455/3 at this altitude and would not get up on plane. I may have been too rich on the needle as I didn't want to toast the motor. Let me know how things go in Vegas. Thanks', Glenn2000 feetWhat is the Elevation in Vegas?i was also going to start with an octura x457 3 blade prop its a pre exr picco .67 with mods done to it any input would be helpfull
Enter your email address to join: