Stainless Bullet Nuts

[Jan Kinley]

Just finished some bullet nuts made from 303 Stainless Steel with a nice tight H2 thread limit so no need for a jam nut. These boys will polish up like chrome and last forever. Sizes are 4mm, 10-32 and 1/4-28. On the accessories or props page. Also made from solid Brass.

http://www.kintecracing.com/Accessories.html

 

[FloridaScaleBoater]

Jan, like the looks of you prop balancer

Do you sell just the shaft's without the complete balancer?

 

[Jan Kinley]

Yes I can do that but I do not have any extra 3/16 shafts. Will be about a month till I finish them up.

 

[FloridaScaleBoater]

Yes I can do that but I do not have any extra 3/16 shafts. Will be about a month till I finish them up.

And that is the size I would be looking for??

 

[Andy Greene]

Jan, like the looks of you prop balancerDo you sell just the shaft's without the complete balancer?

And that is the size I would be looking for??

Geeze <_<

worst case scenario you pay $45.00 bucks for the whole 1/4 balance gig- Its nice stuff !!!

Pony Up and buy one, the guy isn't here to part out his stuff

Get a couple of them fancy prop nuts while your at it too :huh:

See you and Nancy in Tampa ??? B)

Andy

 

[VansRacing]

Just finished some bullet nuts made from 303 Stainless Steel with a nice tight H2 thread limit so no need for a jam nut. These boys will polish up like chrome and last forever. Sizes are 4mm, 10-32 and 1/4-28. On the accessories or props page. Also made from solid Brass.http://www.kintecracing.com/Accessories.html

I use a magnetic balancer to work and maintain my props also. They work great and are rugged.

The short shaft as you have, helps to lighten the assembly for a more accurate balance and is nice when you have to take the prop on and off as much as you do when getting one right. I typically spend 1-1/2 to 2 hours per prop when building a hand worked prop but they are woth the extra trouble once you see the differance.

GREAT PRODUCT Jan!

-Carl Van Houten,