Setting for Pipe on CMB .80 with CMB Pipe?

[nitrotoys]

Whats a good lenght for the engine and pipe?

thanks for any info on this.

 

[Anders_Martinelle]

In a rigger,start at 12" and go down.

It depends always of what setup you are going to run.

Also if you have mods in the engine or not?

Anders

 

[nitrotoys]

Its in a mono hull, Has the Andy Brown P/S work done on it. I have been playing and playing with settings, and about 12.5 works pretty well for me. But was looking for other if there is, also running 10% nitro

 

[TimD]

If it's the big belly CMB pipe and the exhaust timing is around 186 degrees try 11 5/8 inches. Massive torque from that pipe / pipe length

 

[nitrotoys]

Thanks guys,

Now you said something about the big belly pipe, It just looks like a HUGE STINGER Pipe, Is that what your talking about?

and i dont know the exhaust timing.

 

[nitrotoys]

are you talking 11 5/8 from glow plugs to weld on fat part of pipe? Or to the pressure fitting, its just about 1/4 past weld.

dont know if that matters or not.

 

[TimD]

From Plug to weld.