Servos in a 44 seaducer

[seaducerpete]

what servos are you using in the 44 inch seaducers

 

[Joe Warren]

what servos are you using in the 44 inch seaducers

Pete you can Go to Seaducerboats.com & click on Nitro mono`s to view the building instructions. I run a 1/4 scale on the turn servo & use the Aeromarine mount. Also run a std servo on the throttle & a 225 on the third channel. with a 6 volt 1400mah & a receiver that lit radio box gets real tight. You need to think SPACE before you ever start assembly. Hope this help you out? jw

 

[BB Mods's]

DS8711 steering

DS811 throttle

DS811 remote needle

5 cell 6v hump pack

 

[RaceMechaniX]

I am running a HiTech Hitec HS-7955TG digital on the rudder and Futaba S9550 low profile digital on the thottle and mixture.

Tyler

 

[Roxyflash]

I am running a HiTech Hitec HS-7955TG digital on the rudder and Futaba S9550 low profile digital on the thottle and mixture.

Tyler

The low profile servos are nice and clean way to set it up.Always like the servo standing up easier to work on.

 

[Tom Foley]

The low profile servos are nice and clean way to set it up.Always like the servo standing up easier to work on.

AMEN to that ! Standard stuff for me as well , 1/4 scale rudder 3003 throttle

 

[Peter Zicha]

Well Tyler fancy meeting you here , I use a Futaba S9157 digital for my steering on my Neu 2230 powered Sniper....425 in/oz and its the same physical size as the generic Futaba S3003 with a faster responce and almost 10X the torque

The Snipers are about the same physical size as the Seaducers , My setup is just under 20 lbs and can easily do 70mph+ and it has never missed a beat steering

http://www.youtube.com/watch?v=3UJ-fZfbtKQ

 

[RaceMechaniX]

Hello Peter,

I am scattered across too many forums and too many boats.

I like the 9156 and 9157's a lot. I have started using those in new boats. The FE conquest uses the new 7.4V HiTech 7950TH. Lots of torque with super speed and no regulator required.

Tyler