Seaducer 44" with 101RS Setup

[RonShaw]

Hey,

I wanted to toss out that I purchased this boat from Kip and I am looking for tips from some of you mono experts out there. Joe Warren hopefully will chime in and Julian threw out a couple of suggestions the other day. I now have the right Macs 15cc pipe for the boat and Joe and Julian suggested Mark's 467 and 470 prop will work very well. Julian suggested starting at a length of 12" for pipe length. Any other comments or suggestions for setup and heat racing will be appreciated. Thanks.

 

[Joe Warren]

Sent you a P/M

 

[RonShaw]

Sent you a P/M

Thanks again Joe.

 

[shoboat]

Ron,

I need your address again.

Thanks For The Order,

Mark Sholund

 

[RonShaw]

Ron,

I need your address again.

Thanks For The Order,

Mark Sholund

PM sent Mark. Let me know when they are ready. Thanks.

 

[shoboat]

Ron,

It will be next week as I am booked for the Nats the rest

Of this week.

Thanks I Received Your Message,

Mark Sholund

 

[Daniel's Racing]

I realize a Seaducer uses different props than a Razor but I have a CMB 101 RS in it and it will turn a lot of prop. I tried all the small stuff 462,465,467,470 and others of various piches and cup that were recommended buying almost 6 props way to small(and a step 2 down shafts to run the 3/16" props)before realizing it would pull gas sized props without any problem. Went to props like 7016, 7018,2814 and things got much better.

Get at least the 470 done up. The 101 should pull hard and handle properly with as much as a 472 on it.???

With a 7016-410 running with the power robbing big 2' long black CMB quiet pipe. (now I use the Mac's 15cc pipe much better)

View My Video

Same for the rigger with the 101 tried all the 1667's of every pitch and cup and went to a 2916 modded and it picked up 15 mph till lake gods got it than ran a 2716/10 bone stock and lost about 6mph but still not bad.

With a stock 2716/10,

View My Video