Rossi 7.5

[normlee]

Hi, Just purchased and looking for prop advice for a Rossi 7.5, k&b leg, Irwin pipe on a HTB 360 please?

I am also looking for a Don Ferrette or appropriate needle valve to replace the one it had on it.

Thanks Norm,

 

[Robert Pickard]

K needle is also good Jerry Crowther has them

 

[BradSpencer]

Hi Norm,

A KRE needle block is the hot ticket. Very reasonably priced, made in Aus.

I have a pic of the OB version in my gallery.

[email protected]

If you need to source an OS inflight needle assembly, I have plenty in stock.

I have a couple of HTB360's. Many have success with the X series props on these hulls(X447, X448), I prefer to run props with more lift such as a mod Octura 1450 or ABC H7 which take a little more setup time but I feel provide a better running attitude without adding a lot of extra weight.

I have never ran a Rossi powerhead, I can't give any accurate info there.

 

[normlee]

Thanks for the replies, Sent you a PM Brad.

Norm,

 

[jaxracer]

Hi Norm,

A KRE needle block is the hot ticket. Very reasonably priced, made in Aus.

I have a pic of the OB version in my gallery.

[email protected]

If you need to source an OS inflight needle assembly, I have plenty in stock.

I have a couple of HTB360's. Many have success with the X series props on these hulls(X447, X448), I prefer to run props with more lift such as a mod Octura 1450 or ABC H7 which take a little more setup time but I feel provide a better running attitude without adding a lot of extra weight.

I have never ran a Rossi powerhead, I can't give any accurate info there.

What Brad said. A 1450 or x450 detongued should put you in a pretty good prop range for that combo.

-Mitch

 

[normlee]

I have been messaging Mark Sholand about a prop for this setup. Will a 1450 with Lynx cut and 3.60" of cup do the trick?

Thanks Norm,

 

[BradSpencer]

Hi Norm,

Mark knows his stuff. What he suggests will be on the money, or ver very close.

 

[normlee]

Great thanks for all the replies