Rico Gas Rigger with Quickdraw Engine

[BobBonahoom]

This boat and enginer are now SOLD

I am selling a Rico Rigger built by Ritchie Lind last winter. This is a new boat that has not raced, but it has been run a few times. The boat has a Quick Draw Pioneer 30.5 cc engine with ceramic bearings.

The boat and engine are being sold together, complete and ready to run, or I will split them as shown here:

1. The boat alone is $800 US. Includes shipping in the lower 48 states. Rico Rigger with Accutech hardware, servos, FAAST receiver, ABC 2918 prop, shaft, etc. The boat also has a throttle servo actuated microswitch in the radio box wired for positive engine kill. Just drop an engine (with mount) onto the isolators and it is ready to run. The boat is set up for a Quickdraw engine in an Accutech mount and a 100 degree hot pipe. The boat comes with 2 cowls. One is the stock one piece cowl, which is fiberglass. The other is a ZippKits molded cowl with a separate wood carb cover. See photos for details.
2. The QuickDraw engine alone is $1,000 US. Includes shipping in the lower 48 states. This is a Quickdraw Pioneer 30.5 cc (2 mm stroker) with ceramic bearings, QD header, hot pipe and add on muffler. The engine has an EZ Start and comes with an Accutech mount, less the rubber isolators. It has an AM collet and a throttle arm system. Spare parts include a 2mm stoker crankshaft, 20 exhaust O-rings, 2 new carb barrel inserts, several gaskets and a carb rebuild kit. See the photos for details.
3. The boat complete with engine is $1,750 US. Includes shipping in the lower 48 states.

Pre-payment by Pay Pal required before shipment of any item.

The original cost of these items was as follows:

• Boat + radio gear: $960 plus aprox. $200 = $1,160 (including hardware)
• Engine: $1,440 (as described above)

Total original cost: ~ $2,600

 

[Bob Morton]

Wow what a deal and it's built right

 

[nitro freak]

I will Take it

 

[BobBonahoom]

The boat and engine are now sold to Henry.