Pro-Boats

[Doug Ashby]

Do the Pro-Boat hulls measure up to 1/8 scale requirements?

Can they legally be run in 1/8th scale if you convert them to nitro?

 

[Dennis Whitt]

thats funny that you ask that.Because I was looking at some pics in RCBM.It looks like other than the transom ,Blacked in windsheild,carb blister and the ridge area under that carb blister on the deck.That it would make a nice boat as long as the dimensions are correct.Oh ! and those pesky tie down nuts on the back would have to go too.

 

[Doug Ashby]

I knew there would be some minor modifications, what I was curious about was if anybody out there had actually measured one.

 

[waltr]

If I'm not mistaken,the rear ride pads would also have to be removed for IMPBA.

 

[P THOMAS]

I read he wants to make a scale hydro out of it. So the rear sponsons are correct.

You just need to add a clear windshield and driver to make it work for scale. Go find the master hull roster and get the measurements there and then check the proboat lenght. I would think it would work ok.