Parts Wanted Parts Wanted 15cc K90 carb

[Tom Bush]

Hi guys looking for two of these . If u got one or two pm me please .thx

looking for 2 of these. I think they are K90 nitro carbs . I like to find new, if possible .
i have other new carbs to trade for 15cc motors.

 

[brad nichols]

Good luck, you could try Al Hobbs

Brad

 

[Tom Bush]

Can’t find Al Hobbs

 

[AgafonovRoman]

This can be addressed to Frank Werner from Germany. You can find him here on IW. He can have it.

 

[Wasted wages]

Hi guys looking for two of these . If u got one or two pm me please .thx View attachment 312699

i have other new carbs to trade for 15cc motors.

What other carbs do you have to trade ?
Any pictures?

 

[brad nichols]

Al's email [email protected]

 

[NITROSNIFER]

PM me

 

[Al Hobbs]

Al's email [email protected]

That is not my email. [email protected] is the correct email.

 

[brad nichols]

Sorry Al it was the last one I had

Brad

 

[Jeff Lutz]

Hi guys looking for two of these . If u got one or two pm me please .thx View attachment 312699

looking for 2 of these. I think they are K90 nitro carbs . I like to find new, if possible .
i have other new carbs to trade for 15cc motors.

I have this one I will sell for $70 shipped. Its a version before yours with a different velocity stack.

 

[Tom Bush]

Thx Jeff but that does not help me . I actually have a few of those but I am looking for two with the molded in velocity stacks on them.

 

[Jeff Lutz]

Thx Jeff but that does not help me . I actually have a few of those but I am looking for two with the molded in velocity stacks on them.

I tested the one you like also. I have those but need to keep them in case I sell my K90’s. You can fit Mac .67/.84 carbs easily to a K 90 and they run better. You could have Speedmaster make you some also. I ran 119 mph with .510“ carbs with twin K90’s many years ago. With the long intake on those engines I prefer short bell carbs.

 

[Tom Bush]

This is the motor I am looking for carbs for .

 

[Tom Bush]

This is the motor I am looking for carbs for .

 

[Tom Bush]

The carbs on the motor on the pic do not have a needle . does that mean you must use a remote needle? I reall do not want to use remotes as I an trying to keep the look as a real v6 motor.
good low idle is what I want .

 

[Mike Hughes]

You gonna need remote needles with those carbs. Now that I think about it, I am not sure there is a carb that size with an needle. Most are remote.
Mike

 

[Zimmerman]

I have 2 of the carbs you might be looking for. One is stock, the other has been machined off. $160 + the ride if they will help you.
Rich

 

[Tom Bush]

I have some of these carbs. Very unique setup. The barrel slides in and out. With this is the needle that slides in and out with the barrel giving you total adjustments in fuel flow with air flow. This will probably be the best for low idle. the side barrel sticks out and it interferes and hits the motor intake. But I can have some alum cyclinders made to raise the carbs just enough to fit and use extra long screws. i just don’t like the looks but I might have to get over that. Hear some pic ,has anyone use these carbs?