NEW LEECRAFT XT-460 TUNNEL HULL STAND

[JSCARPINO]

This is the New Leecraft XT-460 Tunnel Hull Stand.

The Stand is 44" Long X 7 1/2" Wide X 5 1/2" High

The Stand has a long front end to help protect the long

thin Sponson Tips from being hit if the stand should slide

while in transit.

The Stand also has an adjustable engine start pressure plate

that will transfer the pressure of the starter as it pushes down on the

engine through the engine mount and directly to the stand.

The Stand will cost $95.00 plus S&H

PM if intrested.

 

[topfuel443]

Joe, any plans to do stands for other boats in this style stand? Namely HTB's?

What is it made out of? Delrin?

Very nice work as usual... That has some thought put into it.

~James

 

[JSCARPINO]

Joe, any plans to do stands for other boats in this style stand? Namely HTB's?
What is it made out of? Delrin?

Very nice work as usual... That has some thought put into it.

~James

Hello James

I can do any hull and if your interested I can send out a .pdf Information sheet

that you can measure your hull and I can then design around it. (need your normal email address)

I would not charge for that since then I would have the stand set and ready to sell.

I am going to revise my Info sheet on tunnel hulls to allow for the proper placement

of the engine start pressure plate distance off the transom of the different hulls I do.

Thanks for the nice words.

My Material is a Composite Plastic I have made to my specs and does not

require painting and holds up well to Nitro....

PS I have sent stands to France, Australia and The Netherlands and I have found

with my size boxes I need to use the shipping using USPS is about $43.00 which is

way way better than UPS which is about $250.00 Go Figure.......

Joe

 

[topfuel443]

Yeah, USPS is definitely cheaper for international stuff, most people don't realize that. I have a US address, as I am getting ready to move back to the states so it wont be an issue for me.

I would like to get them made for an HTB 290 (.21 size) and an HTB 360 (7.5 size hull)

Please send me the measurement/info sheet, and I will get it back to you. I would definitely like the motor mount pressure point feature. Its a nice design!

~James

[email protected]

 

[JSCARPINO]

Hello James

I will send you some drawings in a few days.

Thanks

Joe