• If you have bought, sold or gained information from our Classifieds, please donate to Int'l Waters and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

Need a carb and backplate

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Shnick

Well-Known Member
Joined
Mar 5, 2003
Messages
229
Hey all, open your junk drawers, i need a carb and backplate for a picco .80 (not exr). i also need a pipe for the same engine. the hole in the backplate is 5/8" dia.

also, the pic attached is my engine. (the carb in the photo does not fit.) if you know what its for, and/or want to trade, let me know...

Thanks, Shnick
 
imhave one like that the whole engine i'll trade it some of value. tell me what you would like to trade.
 
Send me the ID of the case, and a picture of the crank pin or dimensions of the drive pin. I have a huge box of rear plates. I might have something.
 
Is the carb the correct throat bore you want to use? If so, then machine an adapter, if the carb snout is smaller than the rear plate. I have machined dozens, works great.
 
I got a carb and disc rotor and back plate for .80 exr. Not sure if it will work or not. They look the same. Carb is drilled and tapped for OS in flight remote needle.

Ken B :ph34r:
 
ok, here's what i need. a carb is a must, the carb screws look like they've been hacked on, so i dont know what original equipment looked like...

holes are 1.187" apart, as seen in the photo...

Thanks, Shnick :D
 
Last edited by a moderator:
Shinck

The holes in my backplate look to be 1.187" apart (center to center) Its difficult to be sure holding calaper to what you think is the center of the hole.

Ken
 

Latest posts

Back
Top