Parts Wanted Looking for Rossi 21 Piranah Carby and retaining pin

[Shane Bastick]

Looking for a Rossi 21 Piranha Carby and carby retaining pin, pic attached of the engine showing carby I need

plus post to Australia

thanks

Shane

 

[Brian Sorgente]

I might have some parts for one of those Shane. I'll check for you tonight.

Brian

 

[Stephen Roberge]

Shane well this one work for you?

 

[Shane Bastick]

I might have some parts for one of those Shane. I'll check for you tonight.

Brian

thanks Brian

 

[Shane Bastick]

Shane well this one work for you?

Hi Stephen,
the nova carb external bore is to small, but thankyou

 

[Brian Sorgente]

thanks Brian

Sorry Shane, I couldn’t find it. I may need to dig around a little more tomorrow.

Brian

 

[Shane Bastick]

thanks for looking Brian

 

[brad nichols]

What is the neck size? maybe KRE or Speedmaster could work? I do have some Rossi carbs but would need to measure.

Brad

 

[Shane Bastick]

Hi Brad,
I'll have to check, its larger than a standard nova, something like 17mm or so,

 

[taber]

I have the carb but lost the main needle. It still has the 3rd ch adjust fitting but missing the high speed needle.

 

[David Krienke]

I have the carb but lost the main needle. It still has the 3rd ch adjust fitting but missing the high speed needle.

I have one and its a pain to tune it . If you get the main needle spun out enough on the adjuster arm and the needle to make it rich enough it about falls out in the water unless you attach it to 3rd channel servo. Its a bad design. I would make an adapter and use a os carb or any other carb just my opinion.

 

[taber]

Sounds good. I think I will install a plug and use a remote needle.