looking for hardware

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

anthony_marquart

Well-Known Member
Joined
Nov 4, 2003
Messages
3,745
I'm looking for used hardware. About the size of the Fullers, Solinger or smaller octura stuff.

Doesn't have to be perfect. I can polish and replace bushings.. I like the rudder mounted to the strut bracket style but anyting will do.

I'm looking for 2 strut and rudder combos..

Thanks

[email protected]
 
Looks nice. I wonder what the dimensions on that stufff are? The strut looks too short.
This is what I plan on using for the .12 size rigger for F/E - Not used but very decent hardware for the money.
<a href="http://www.minicatracingusa.com/parts.html" target="_blank">http://www.minicatracingusa.com/parts.html</a>

Andy
Looking at my minicat- your right, the strut is too short for any good adjustability. Just hit you setup spot on :p
 
Last edited by a moderator:
I pretty much wear my stuff out. I would go with Fuller's stuff on the sport boat, the 12 cell size. It's hard to beat Solinger's stuff for little riggers.
 
anthony

if you dont get in a hurry i have a set of this hardware on order. should be here early next week. will post some sizes when it gets here. i do know it uses a metric shaft but can be modified to use octura 3/16 bearings.

jon
 
got new hardware. the rudder will work perfectly. but the strut is short. if your tub clearence is more than 5/8" than it will not work. i slotted the strut and mounted the brackets as low as possible. will have about 1/8" of adjustment. had to ream out the strut to take the octura bearings. the nose also takes 5mm drive line tubing. so something else i have to modify. hope this helps.

jon
 
Back
Top