Longer Antennas

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

TomGracey

Well-Known Member
Joined
Dec 5, 2018
Messages
466
Looking for a source for longer antennas for Futaba RX's they use to sell something like a 400mm antennas but do not remember who
 
This should be the product code for the 400mm antenna, there is also a 500mm as well

400mm - FUTRXANT400

500mm - FUTRXANT500
 
I also bought one recently from Gizmos. Still have to find time and a good manual to install it.
 
I also bought one recently from Gizmos. Still have to find time and a good manual to install it.

so install it it’s easy your receiver has four tabs two on each side take a small little screwdriver press and the tabs separate the top half on the bottom half pull out the small antenna wire disconnected connect a new antenna wire feed it through put them back together and you’re done
 
Just curious are people having problems wth range on there current factory antennas?
Or are people going longer for a more definate signal?
I assume people are still leaving the antenna inside the box anyway.

David
 
Just curious are people having problems wth range on there current factory antennas?
Or are people going longer for a more definate signal?
I assume people are still leaving the antenna inside the box anyway.

David


Some boats have carbon fiber so it’s always best to get the antenna as far outside the boat as possible. I had a antenna slip back in the boat and I lost radio since then. I put the longer antennas on all my boats and ensure there plenty sticking out the boat
 
Just curious are people having problems wth range on there current factory antennas?
Or are people going longer for a more definate signal?
I assume people are still leaving the antenna inside the box anyway.

David
David, the actual antenna is only the part that is stripped and tinned. The rest of the antenna wire is surrounded by an insulating braid that keeps out interference. As Julian said, the added length is to get that stripped antenna end as far out of the hull as possible, especially if the hull is built with carbon fiber. Carbon fiber is a material that blocks some or all of a transmitter's signal, making an "in radio box" antenna installation worthless
 
Will these work on t-fhss/sr receivers?
I do not know if the will work on the receivers that you have ,I use them on the fass receiver R603ff and R 603FS. let me know what number receivers you have and I will find out if they will fit your receivers before I send the antennas.
Thanks
Walt Barney
 
I do not know if the will work on the receivers that you have ,I use them on the fass receiver R603ff and R 603FS. let me know what number receivers you have and I will find out if they will fit your receivers before I send the antennas.
Thanks
Walt Barney
R304SB T-FHSS S BUS 2
 
I will take 5 of those antennas Walt. Can you send me a Paypal invoice?
 

Latest posts

Back
Top