- Joined
- Apr 1, 2002
- Messages
- 4,108
We are going to start running P Limited Sport Hydro at District 8 Points races this year. Since I have lots of 1/10 Scale batteries and ESUs, that could be used in a P Limited Sport Hydro, I decided to design and build a hull. The hull is 30" in length with an 8" tunnel width and an overall width of 13.5". At a P Limited Sport Hydro race I watched last year, I noticed some boats were blowing off. They were going crazy fast.
I decided to design some down force into the front of the center section and the sponsons. Since I haven't had an opportunity to run the design WOT throttle yet due to wind and water condition, I don't know if it might work. I had to increase the AOA on the sponson bottoms after the boat acted more like a red submarine than a hydroplane the first test session. With the increase in AOA, the boat now get up on step quickly. I'm considering naming it "Miss Cialis."
The motor is a HUFF 2150 KV and a 150 amp SeaKing ESC. The first successful test run was with a Prather 220. Actually, the unsuccessful first test session was with the Prather.
JD
I decided to design some down force into the front of the center section and the sponsons. Since I haven't had an opportunity to run the design WOT throttle yet due to wind and water condition, I don't know if it might work. I had to increase the AOA on the sponson bottoms after the boat acted more like a red submarine than a hydroplane the first test session. With the increase in AOA, the boat now get up on step quickly. I'm considering naming it "Miss Cialis."
The motor is a HUFF 2150 KV and a 150 amp SeaKing ESC. The first successful test run was with a Prather 220. Actually, the unsuccessful first test session was with the Prather.
JD