JAE Turn fin pattern

[bzubee]

Looking for a turn fin profile/drawing for the JAE .12 Zipp Kit?

 

[Ron Zaker Jr]

Looking for a turn fin profile/drawing for the JAE .12 Zipp Kit?

Zubes,

PM me your fax number.I'll send you a pattern.

 

[bzubee]

thanks Ron.

Looking for a turn fin profile/drawing for the JAE .12 Zipp Kit?

Zubes,

PM me your fax number.I'll send you a pattern.

 

[SayMikey]

thanks Ron.

Looking for a turn fin profile/drawing for the JAE .12 Zipp Kit?

Zubes,

PM me your fax number.I'll send you a pattern.

I could use a pattern as well Bill Can you email it to me

 

[tmunn]

The one joe at zipkits sells looks to be a good one ..cheap too and heck of a nice guy to support..

 

[SayMikey]

The one joe at zipkits sells looks to be a good one ..cheap too and heck of a nice guy to support..

I second Zipp Kits but hope to use a smaller fin Sponsons drying as we speak Cant wait to run this thingy and build the 21 ZOOM ZOOM ZOOM wonder if my good friend Charles makes a ZOOMIE for a Nova 12

 

[Charles Perdue]

I have a prototype built and tested. I just did not think that there would that much of a demand for a carb for the economy class like the 12. The carb would cost little over half of the Novarossi engine price. There is a very noticeable difference in the performance though.

If there is enough serious interest, I could "Tool up" and make some.

Charles

 

[bzubee]

Will do Mike. Just went to the ZIPP site and the hardware kit is marked SOLD OUT

thanks Ron.

Looking for a turn fin profile/drawing for the JAE .12 Zipp Kit?

Zubes,

PM me your fax number.I'll send you a pattern.

I could use a pattern as well Bill Can you email it to me

 

[bzubee]

Just went to the ZIPP site and the hardware listing is marked "SOLD OUT".