JAE .12 builders...

[Glenn Quarles]

Friends, I have some special aircooled heads coming in that should not required mods for you guys that don't want to run water pickups on your boats. I have ordered 5 sets (the head takes a special head button) and the price should be around $35 - $40.

Glenn

 

[Albert Marroquin]

Friends, I have some special aircooled heads coming in that should not required mods for you guys that don't want to run water pickups on your boats. I have ordered 5 sets (the head takes a special head button) and the price should be around $35 - $40.

Glenn

Can you send me pictures. [email protected]

Thanks Albert M

 

[Glenn Quarles]

This is a picture of the head, but it sits on the marine head button a little higher (the edge of the head button actually shows).

Glenn

 

[Madduck]

Hi Glenn,

Did you get my PM about NR12? Thank you

DR

 

[Ron Olson]

Put me down for one. Let me know later the total price with shipping.

 

[Glenn Quarles]

Hi Glenn,

Did you get my PM about NR12? Thank you

DR

DR, yes. I replied as soon as I got it...do you need me to resend?

Glenn

 

[Glenn Quarles]

Put me down for one. Let me know later the total price with shipping.

Will do.

Thanks,

Glenn

 

[Madduck]

Hi Glenn,

Did you get my PM about NR12? Thank you

DR

DR, yes. I replied as soon as I got it...do you need me to resend?

Glenn

Hi Glenn, Thank you.

 

[Madduck]

Hi Glenn,

Did you get my PM about NR12? Thank you

DR

DR, yes. I replied as soon as I got it...do you need me to resend?

Glenn

Hi Glenn, I though PM did not work. Thank you.

 

[153stars]

As I think of a cowl design, if there was liberal front venting how much would have to be exposed to the outside air. Trying to get the carb covered but not choke it out.Would a similar size hole above it vent off enough heat?

 

[Glenn Quarles]

As I think of a cowl design, if there was liberal front venting how much would have to be exposed to the outside air. Trying to get the carb covered but not choke it out.Would a similar size hole above it vent off enough heat?

It doesn't take a whole lot of air intake to get adequate cooling if your air exit is big enough. You may just have to play with it a bit.

Glenn

 

[TERMINATOR]

As I think of a cowl design, if there was liberal front venting how much would have to be exposed to the outside air. Trying to get the carb covered but not choke it out.Would a similar size hole above it vent off enough heat?

It doesn't take a whole lot of air intake to get adequate cooling if your air exit is big enough. You may just have to play with it a bit.

Glenn

i am in process of finishing up my new mold for cowls, they will be released here soon guys..thanks

they should fit the 20 boats as well, will see

tk