identify this hull

[Chris Dixon]

Can anybody identify this hull ? It is 46" long and is set up for a .60 engine.

 

[Duck899]

DUMAS CF 60

The CF stands for Competition Fiberglass

 

[Kez]

Agreed. It is a Dumas CF deepvee 60. From the picture, it looked like the deck was sagging. I have built all three sizes of the Dumas vees in the 70s and 80s and the deck would sag and dish over time. It is worse if you do not install the bulkheads.

 

[Duck899]

Some of us used to cut down the sides about an inch and taper the nose down at the front for better cornering and some downforce on the front at speed. They were good in their day untill Frank Ward came out with the Wardcraft.

 

[David Bryant]

yep, Dumas CF series Deep Vee hull. I had one as a kid

 

[Chris Dixon]

thanks guys...I might be getting one on trade

 

[Chris Dixon]

Well I got the dumas cf60...paint looks good and its got a aluminum marine specialties twin rudder system for hardware....looks good.....the ops .60 engine looks dated but has good compression...any advise on carb tuning or any known issues with this combo?

 

[David Bryant]

Well I got the dumas cf60...paint looks good and its got a aluminum marine specialties twin rudder system for hardware....looks good.....the ops .60 engine looks dated but has good compression...any advise on carb tuning or any known issues with this combo?

post a few more images if you would showing engine detail, internal section, and rear-end/rudder assy, etc.,...

 

[Rokieboater]

Wardcraft..... Haven't heard that name in awhile. Frank Ward made a great 40 mono.

Robert