- Joined
- Sep 5, 2007
- Messages
- 1,614
up for sale is a bench sander I made from a furnace motor and 9 inch disc,,it works great for small and large sanding needs while you are building,,i bolted it down to a table and had it plugged into a on-off plug switch,,also I used spray adhiesive with a regular sheet of sand paper and trimmed it,,$60.00 shipped lower 48,,,
next is a real nice pitbox you can set up as 12 or 24 volt,,i put the frame on the front and screwed my power panel to it and plugged it into the side on the 12 volt still leaving the 24 volt if needed to start my boats,,worked real nice,,$35.00 shipped lower 48,,$85.00 if you want both shipped lower 48,,thanks for looking and Happy Holidays,,gary
paypal is [email protected]
next is a real nice pitbox you can set up as 12 or 24 volt,,i put the frame on the front and screwed my power panel to it and plugged it into the side on the 12 volt still leaving the 24 volt if needed to start my boats,,worked real nice,,$35.00 shipped lower 48,,$85.00 if you want both shipped lower 48,,thanks for looking and Happy Holidays,,gary
paypal is [email protected]
Last edited by a moderator:
