K Ken Webb Well-Known Member Joined Jun 14, 2007 Messages 921 Sep 23, 2014 #1 What type flotation is being used in F/G hydro hulls ?
Samuel Hagan JR Well-Known Member Joined Jul 18, 2010 Messages 4,650 Sep 23, 2014 #2 I use pool noodles. I replace them half way through the season.
B brad nichols Well-Known Member Supporting Member Joined May 10, 2010 Messages 3,006 Sep 23, 2014 #3 Either the pool noodles or foam insulation sheet cut to fit. Brad
Ray Sametz Well-Known Member Supporting Member Joined Nov 22, 2003 Messages 7,187 Sep 23, 2014 #4 I use pool noodles, if you cut seal the ends with a pass from a propane torch.
H Hydro Junkie Well-Known Member Joined Oct 2, 2006 Messages 5,765 Sep 24, 2014 #5 Stay away from the spray in and two part foams. I've seen them blow a boat's seams apart. They also can trap and hold water/fuel residue Last edited by a moderator: Sep 24, 2014
Stay away from the spray in and two part foams. I've seen them blow a boat's seams apart. They also can trap and hold water/fuel residue
Duck899 Well-Known Member Joined Jun 11, 2002 Messages 3,186 Sep 24, 2014 #6 You can also use copper pipe insulating foam tubes. They are smaller in diameter and fit better in tight areas. Available at any hardware stores.
You can also use copper pipe insulating foam tubes. They are smaller in diameter and fit better in tight areas. Available at any hardware stores.