favorite cmb rs07 21 quite pipe ???

[bob miller]

what is your favorite quite pipe for a cmb rs07 21 inboard in a 33" seaducer mono ?....thanks...bob

 

[julianconde]

Cmdi fat belly pipe is the best

 

[FloridaScaleBoater]

Cmdi fat belly pipe is the best

Yup,,, easiest to needle, best low end to W.O.T.

There are higher RPM pipes, but the Brown Fat pipe is all around the best

 

[Rokieboater]

I use the OPS 3280 Pipe and pipe Al Hobbs sells which is a close replica of the 3280 pipe.

Robert Holland

 

[FloridaScaleBoater]

I use the OPS 3280 Pipe and pipe Al Hobbs sells which is a close replica of the 3280 pipe.

Robert Holland

But not a muffled pipe

 

[julianconde]

Cmdi fat belly pipe is the best

Yup,,, easiest to needle, best low end to W.O.T.

There are higher RPM pipes, but the Brown Fat pipe is all around the best

OPS 3280 is also a great pipe but it has to be the non muffled type. I ran that very successfully won the nats with that pipe

 

[bob miller]

is the CMDI pipe a quiet pipe ?....thanks.....bob

 

[julianconde]

you need to get a OPS 3280 open nitro pipe or a AB Fat Belly Pipe those 2 pipes will work very well

 

[FloridaScaleBoater]

is the CMDI pipe a quiet pipe ?....thanks.....bob

Yes, the Brown (CMDi) fat belly pipe is a quiet pipe, Good luck finding one

The OPS 3280 is not, but easy enough to add a stinger muffler to.

Along with the CMB 21 Nitro pipe, is also a good pipe, but is not a quiet pipe

 

[julianconde]

Bob if you are looking for some i have a pair i might consider selling you ;-)

 

[Duck899]

I use this little CMDi XT pipe on my speedmaster with the CMB 21 RSV....won alot of races and high points titles.

 

[bob miller]

Bob if you are looking for some i have a pair i might consider selling you ;-)

julian , you have a pm , bob

 

[dwilfong]

The current CMB nitro pipe is a great pipe.

You have to close the stinger down to get the heat in the eng.

When you put the brass tube in it take it to the middle of the belly.

It will be a quit pipe then.

Make sure you drill a small hole in the tube just before the start of the stinger to let the water out.

David