JSCARPINO
Well-Known Member
- Joined
- Jul 4, 2005
- Messages
- 464
Hello All I am selling this set of Exhaust Throttles & Venturi's for a twin engine set up.
The Exhaust Throttles were made for me by Cee Bee Marine (Carl Brey)Carl was known for his High quality Machine Work.
The specs for the Exhaust Throttles are:
.9040" Engine Exhaust outlet required. + - .0200"
.7200" bore through exhaust throttle..8860" O.D. @ tuned pipe connection.
Throttles are set to 12 degrees for Hydro use.Exhaust barrel is hard anodized aluminum and will not bind.
10-32 brass water barbs required for cooling.
The specs for the Venturi's are:
.5095" O.D. for fit into back plate of engine.
.3800" bore at minimum..4500" bore at maximum.
Over all length from sealing O ring is 1.125"
The Venturi's do not have a spray bar but instead have 6 holes symmetrically spaced inside a brass ring so as to atomize the fuel in a concentric pattern.
I will sell all 4 parts for $125.00 plus S&H
The Exhaust Throttles were made for me by Cee Bee Marine (Carl Brey)Carl was known for his High quality Machine Work.
The specs for the Exhaust Throttles are:
.9040" Engine Exhaust outlet required. + - .0200"
.7200" bore through exhaust throttle..8860" O.D. @ tuned pipe connection.
Throttles are set to 12 degrees for Hydro use.Exhaust barrel is hard anodized aluminum and will not bind.
10-32 brass water barbs required for cooling.
The specs for the Venturi's are:
.5095" O.D. for fit into back plate of engine.
.3800" bore at minimum..4500" bore at maximum.
Over all length from sealing O ring is 1.125"
The Venturi's do not have a spray bar but instead have 6 holes symmetrically spaced inside a brass ring so as to atomize the fuel in a concentric pattern.
I will sell all 4 parts for $125.00 plus S&H
