Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Normal
Duane, I'd do it pretty much like Bill-1/16 birch ply filling the rear center floor glued with slow epoxy(I like West Systems). On the transom I'd add .030" carbon fibre inside and outside. Dumas used the soft Luan mahogany ply on the transom too and the bolts/nuts would compress this wood easily. Nuts/bolts would loosen up when the boat was run hard and then the holes for the rudder mount would get enlarged/elongated. Also put a carbon fibre doubler where the skid fin mounts for the same reason. Good luck,Glenn
Duane, I'd do it pretty much like Bill-1/16 birch ply filling the rear center floor glued with slow epoxy(I like West Systems). On the transom I'd add .030" carbon fibre inside and outside. Dumas used the soft Luan mahogany ply on the transom too and the bolts/nuts would compress this wood easily. Nuts/bolts would loosen up when the boat was run hard and then the holes for the rudder mount would get enlarged/elongated. Also put a carbon fibre doubler where the skid fin mounts for the same reason. Good luck,
Glenn
