Cooper 67-80QFE pipe-SOLD

[Don Ferrette]

Cooper 67-80QFE pipe, un-cut with 90 degree pressure tap. Would not clear under deck application it was intended for (radio box was in the way). $50 plus shipping. SOLD!

 

[Ray Sametz]

Don, I'll take it. Ray

 

[Don Ferrette]

Sold to Ray. B)

 

[Ray Sametz]

Don, Where's my F---ing Goddam pipe. :angry: Gotcha, you the man, recieved today. Ray B) B)

 

[Don Ferrette]

Don, Where's my F---ing Goddam pipe. :angry: Gotcha, you the man, recieved today. Ray B) B)

You f---ing check showed up today. Back at ya. :lol: :lol: :lol: :lol: :lol:

 

[Ray Sametz]

Don, What lenght were you running this pipe, ie center of cylinder to start of fat band. On my OPS 67 I'm reading 10-1/8 inches, a tad short for my app. Did you have a header in your app. Thanks Ray :unsure: :unsure:

 

[Don Ferrette]

Don, What lenght were you running this pipe, ie center of cylinder to start of fat band. On my OPS 67 I'm reading 10-1/8 inches, a tad short for my app. Did you have a header in your app. Thanks Ray :unsure: :unsure:

Never ran it, wouldn't clear in the boat it was intended for. 10 1/8" from where to where?? :blink:

 

[Ray Sametz]

Don, What lenght were you running this pipe, ie center of cylinder to start of fat band. On my OPS 67 I'm reading 10-1/8 inches, a tad short for my app. Did you have a header in your app. Thanks Ray :unsure: :unsure:

Center of cylinder to start of flat band is 10-1/8. I think this is too short for my heavy 67 rigger??? :blink: :blink: B) Ray

 

[Don Ferrette]

Don, What lenght were you running this pipe, ie center of cylinder to start of fat band. On my OPS 67 I'm reading 10-1/8 inches, a tad short for my app. Did you have a header in your app. Thanks Ray :unsure: :unsure:

Center of cylinder to start of flat band is 10-1/8. I think this is too short for my heavy 67 rigger??? :blink: :blink: B) Ray

I forgot about those short azz headers OPS uses. Maybe that's why they have that extra piece welded on their pipes we always seem to cut off. :blink: