CMB 101. PIPE INFO (HELP)

[vision craft boats]

Well i found a engine CMB RS 101. and wondering what pipe everyone has found to be the best for that engine in a 90 rigger and A ball park measurement to start with. Any help would be great. Thanks Rich.

 

[TERMINATOR]

Well i found a engine CMB RS 101. and wondering what pipe everyone has found to be the best for that engine in a 90 rigger and A ball park measurement to start with. Any help would be great. Thanks Rich.

hey rich sounds like you jumped off the deep end..lol anyhow i think the guys are using the 15 cc mac unmuffled pipes ..and i have heard a few running the cmb fat belly black 90 pipe?? i have one of each if you want to try them..lmk

tk

 

[ALLAN YUEN]

If you buy cmb 90 black big belly tuned pipe or MACS 15cc silver tuned pipe and put add prather large muffled and must CMB header long pipe ( 5 inches) both good Set up 12"

 

[Chris Wood]

i know it sounds corny but i know several guys running the cmb 67 muffled pipe and working well on them motors.

might check them out as well

chris

 

[Joe Warren]

Well i found a engine CMB RS 101. and wondering what pipe everyone has found to be the best for that engine in a 90 rigger and A ball park measurement to start with. Any help would be great. Thanks Rich.

15cc macs or a 13cc macs. both @ 11 1/4 to 11 1/2 Both work very well.

 

[vision craft boats]

i know it sounds corny but i know several guys running the cmb 67 muffled pipe and working well on them motors.

might check them out as well

chris

Yea Chris, Andy Brown said one of his 67 pipes would work well with that motor as well. Thanks For the info everyone. Rich

 

[Buckshot]

Yep the black CMDi AB67 pipe or the black CMB .67 pipe (they are the same) work well on that motor at 11.25" to 11.5" in an outrigger.

BUT....the best I have found so far is the CMDi Bar Stock .90/1.0 pipe at 11.5" to 11.75" in an outrigger.

-Buck-

 

[RaceMechaniX]

Yep the black CMDi AB67 pipe or the black CMB .67 pipe (they are the same) work well on that motor at 11.25" to 11.5" in an outrigger.

BUT....the best I have found so far is the CMDi Bar Stock .90/1.0 pipe at 11.5" to 11.75" in an outrigger.

-Buck-

I'm with Buck on this one. I have two of the 1" motors both running the bar stock 90/101 pipes one in a mono and the other in a rigger. The rigger likes 11.5" and the mono likes 12.125".

You do have to weld the threaded sections together to keep the threads from vibrating apart, but after that they have been solid pipes.

Tyler

 

[BigChuck]

Also your prop choice range will be Directly related to the Pipe choice you make.