Brushless motor thrust bearing instalation

[riggerman]

Hello to install a Tamiya thrust bearing on my Nemisis brushless motor how much gap should there be between the flex hex and the bearing? Would the thickness off print paper between the 2 surfaces be suffienct as Jayt mentioned for a 700 motor ? Regards Andris Golts.

 

[Paul Pachmayer]

Hello Andris,

Yep, that will be fine.

Paul.

 

[tnrcboatracer]

I think 100 microns (0.100mm) is about right. It just so happens that a sheet of pater is almost exactly 100 microns..... <_<