Reply to thread

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

A technique I copied from one of the nitro gurus was to drain the tank of nitro fuel and fill with FAI 0%, so just oil and methanol.   I use 20% Tecnhiplate.   I will fire the motor with the glow plug for 30seconds so all the nitro is burnt and flushed with the methanol/oil mix.  Then do a similar pickle mentioned above.  Bearings last a long time and no corrosion inside the motor.


If you don't have easy access to 0%, you can order from John Otto at Technology hobbies or I am sure Jerry and others can do the same.


Back
Top