Another EBAY deal of the century

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
30,000 RPM, Ported and polished, and about 5 hp.

Some one is very stupid if they buy this one.

Paul at PPG has been running strykers for years and best he did was 80.2 with a mod H50 prop,

I dont think a Zen would hold tougher at 30k.

20k is at there extream limit.

Must be a HANSON ENGINE :D :D :D :D

I will pay extra for the primer grey paint work. :p :p
 
Hey if you look closely at the boat he actually proves it that it's fast.....It speed all the paint off goin' so dang fast....LOL

Do you think he built it to run while out surfin' in the Ocean?? ANYONE notice it was built for Salt Water but of course, he only ran it in Fresh Water...LOL :lol: :D
 
Dallantine CD3 strut and rutter setup comes with two props one 270 and one 275 two blade razor sharp for speed the rutter is razor sharp
the speed secret is out... not using a rudder but a 'rutter'...lol
 
david cox said:
Nice paint job on the Stryker!!! Is that custom or what?!
It's that new High Visability paint so the umm not so fast can see it about to lap them :D
 
Nice paint job on the Stryker!!! Is that custom or what?!
You guys don't know anything, do you? :blink: IT'S RADAR ABSORBING 'STEALTH PAINT'!

That's why the radar gun that was used (twice) showed 96.7 MPH. It didn't 'see' the Stryker at all...it was clocking the SG on the other side of the pond. :D
 
just sent hime a nice little email....

by the way....he must of had the SPEED GUN set on KMPH
 

Latest posts

Back
Top