Parts For Sale 3.5 K&B shipped in con usa only

[Jonathan DeMaria]

Used,spins. 125$ shipped. Ask away on any questions. I'll do my best to answer.

 

[stefanmackey]

Does it start up? When was the last time it was ran? Compression?

 

[Wasted wages]

12 or 13 mm crank ?

 

[Grimracer]

Looks like a 12 to me.. short head button

 

[Jonathan DeMaria]

Not shure I can look at some #s when I get home about crank. Motor has great compression. 2 yrs ago started on the bench.

 

[stefanmackey]

I'll take it. Sent you a DM.

 

[Jonathan DeMaria]

Still for sale.

 

[Allan Heinrich]

Looks like a 12 to me.. short head button

3.5 right on the crank case.

 

[Grimracer]

Allan,

K+B made a few 3.5s.. the one you have is what's known as the 12mm motor. It used a 12mm ID rear bearing.
The flywheel profile and the thickness of the head button are dead giveaways.

Later and for the rest of the production they were all 13mm motors BUT.. in a few different configurations.
8906
SS
SX

Parts for the 12mm motor can be a bit more difficult to find. The crank case between the 12 and 13 are not interchangeable.

I should go on to say however... there could be mix and matched parts in the motor.. but if you feel its untouched then its a 12mm unit

Grim

 

[Allan Heinrich]

Allan,

K+B made a few 3.5s.. the one you have is what's known as the 12mm motor. It used a 12mm ID rear bearing.
The flywheel profile and the thickness of the head button are dead giveaways.

Later and for the rest of the production they were all 13mm motors BUT.. in a few different configurations.
8906
SS
SX

Parts for the 12mm motor can be a bit more difficult to find. The crank case between the 12 and 13 are not interchangeable.

I should go on to say however... there could be mix and matched parts in the motor.. but if you feel its untouched then its a 12mm unit

Grim

Thank you for the info, I didn't know there where so many variations of the 3.5 outboard. Thanks again!

 

[Jonathan DeMaria]

Thanks Mike. Interested Allen?

 

[Mike Hughes]

Thank you for the info, I didn't know there where so many variations of the 3.5 outboard. Thanks again!

Mike just touch on some of the difference. There were many different iterations over the years. One of the reasons why the namba stock motor rule allows for swapping of parts. It came so many different ways.