24 VOLT INBOARD - OUTBOARD STARTER BOX

[JSCARPINO]

Hello All

This is my new 24 volt Inboard/Outboard Starter

Box.

Dimensions:

10 1/2" Deep X 14 1/2" Long X 6 3/8" High (with Handle 9 1/4" High)

Name or Logo can be engraved on both battery doors. (PM for Info)

The box is well suited for anyone who races both Tunnel Hulls & Inboards.

I have seen people fumble around at the last second in the hot pit area only to not have the correct rotation of the starter to the

right engine. Now just flip the switch and your ready to go.

Has (6) threaded holes to store spare glow plugs.

Comes pre-wired.

L.E.D. Indicators for Inboard (Yellow) & Outboard (Red)

Comes with a Male Plug for you to solder onto your Dynatron Starter or equal 24 volt Starter ( Starter not Included)

Requires (2) Sealed, lead/calcium maintenance-free battery's (Not Included) (Battery no larger than 4" High X 6 1/8" Long X 2 5/8" Deep)

Comes with (2) Banana Jacks to solder onto your Gel Cell Charger.

(Glow Plugs not Included)

This Unit will sell for $145.00 Plus S&H

PM me for more Info or if you would like to re-configure slightly to your liking.

 

[Terry Flynn]

it would be nice if you also added a swith to go from 12 to 24 volts.

But that is a nice setup.

 

[chris1088]

Looks good Joe Ilike it

 

[t_hedlund]

awesome starter box, it would be nice if it had a place for a glow plug driver.

 

[JSCARPINO]

awesome starter box, it would be nice if it had a place for a glow plug driver.

Hello Tom

I did not even think of doing that since I let enough area in the starter

storage section for the starter and a plug wrench and needle nose.

Consider it added.

I will post a picture as soon as I modify it.

Also since I use a power Panel to start my boats, could you tell me

what the most popular Ni-Starter is to use, I like to purchase the Item

if I am going to include a spot for something like that to make sure

it fits and is easily accessible.

Thanks for the Input Tom