2.4 ghz help needed

[Beau Parsons]

I have a Futaba 2.4ghz Magnum T3PM I have 7 receivers to go along with it. My problem is somewhow when I set it up I screwed the third channel all up, I had it where I could richen or lean with my left thumb, but the only way after I did something is if I set the radio to select and scroll to where it says CH3 and I can only go postive or negative with the buttons, I know when I bought this thing I could use I think DT3 or DT4 to lean or richen out. this sucks because I have to look down when racing and push the postive and negative buttons and I have had a few close calls because I need to be watching the boat and not the radio. So can anyone see how to fix this aggrovating problem? I have read the manual and am stumped?I can be reached by phone if need be, any help would be great.

Thanks Beau Parsons

303 704 0923

 

[RaceCraftBearings]

I have a Futaba 2.4ghz Magnum T3PM I have 7 receivers to go along with it. My problem is somewhow when I set it up I screwed the third channel all up, I had it where I could richen or lean with my left thumb, but the only way after I did something is if I set the radio to select and scroll to where it says CH3 and I can only go postive or negative with the buttons, I know when I bought this thing I could use I think DT3 or DT4 to lean or richen out. this sucks because I have to look down when racing and push the postive and negative buttons and I have had a few close calls because I need to be watching the boat and not the radio. So can anyone see how to fix this aggrovating problem? I have read the manual and am stumped?I can be reached by phone if need be, any help would be great.

Thanks Beau Parsons

303 704 0923

Go to this link: http://manuals.hobbico.com/fut/3pm-2_4ghz-manual.pdf

Then scroll to page 54 to read the following with ilustrations.

Initially set functions

DT1: Steering trim

DT2: Throttle trim

DT3: Dual rate function

DT4: ATL function

DT1

DT2

Function Select Lever / FNC-DT

This function allows selection of the function performed by the grip lever (DT3/DT4)

and digital trim (DT1/DT2).

DT3

DT4

Settable functions

ST: Steering trim

TH: Throttle trim

DR: Steering D/R

AT: Throttle ATL

E1: Steering EXP

BK: Brake mixing rate

3C: Channel 3

OF: (function off)

Function select lever setup

1 (Setup item selection)

Use the (CH) button to select the item to be set.

2 (When changing the function)

Use the (+) or (-) button to select the function.

3 When ending adjustment, turn off the power switch before use.

 

[mrgary]

sent you a pm,,should work on your radio,,gary

 

[RaceCraftBearings]

I just love it when people ask for something, someone posts for them and they never check back on it or if they do say nothing in the post.

 

[Beau Parsons]

Race craft bearings Sorry I not had a chance to take the radio and each boat and try to fix the problem? I will let you know if you info helped.

Beau

 

[RaceCraftBearings]

Beau I think I found the radio manual you were talking about but not sure of it.

If not Futaba has many radio manuals online.