1/5th Scale Atlas Van Lines Progress

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Terry Heddin

Well-Known Member
Joined
Nov 19, 2023
Messages
101
Making a little progress on my 68" Atlas Van Lines, Blue Blaster.
 

Attachments

  • 20240318_164425.jpg
    20240318_164425.jpg
    773.3 KB
  • 20240318_164438.jpg
    20240318_164438.jpg
    753.8 KB
  • 20240318_164449.jpg
    20240318_164449.jpg
    720.6 KB
  • 20240318_164457.jpg
    20240318_164457.jpg
    758.2 KB
  • 20240318_164526.jpg
    20240318_164526.jpg
    869.1 KB
  • 20240318_164540.jpg
    20240318_164540.jpg
    742.7 KB
  • 20240318_164548.jpg
    20240318_164548.jpg
    1.1 MB
  • 20240318_164556.jpg
    20240318_164556.jpg
    1.1 MB
  • 20240318_164603.jpg
    20240318_164603.jpg
    745.7 KB
  • Flyer.jpg
    Flyer.jpg
    485.3 KB
Making a little progress on my 68" Atlas Van Lines, Blue Blaster.
One of my favorite boats and drivers all time. That is one big boat. I would recommend having towing capability or maybe a pole with a hook on it in your retrieve boat. Gas Scales are a foot or more shorter than that one and they are an absolute back breaker to lift over the side of a retrieve boat, especially with water in them. I run Blazer Lauterbachs which come in at 51 inches and they are bad enough.

What are your plans as far as paint? Or are you going to just getting it dialed in and then paint?
 
Defiantly planning to get a rope or pole with a hook, or something similar. I found out about trying to put a big boat in the retrieval boat last week. Swamped my 12ft flatbottom while trying to lift my Zippkits SLR Missile into the boat. I plane to test it before paint, so I can change whatever doesn't work.
 
Defiantly planning to get a rope or pole with a hook, or something similar. I found out about trying to put a big boat in the retrieval boat last week. Swamped my 12ft flatbottom while trying to lift my Zippkits SLR Missile into the boat. I plane to test it before paint, so I can change whatever doesn't work.
Yeah that’s a good plan. There’s nothing worse than spending all the time to make a boat look nice and then having it get dinged up when it inevitably blows over or hooks or whatever because your setup isn’t dialed in. It’s a lot easier to make any needed repairs or changes without worrying about your 500.00 paint job in the process.
 
Back
Top