Search results

It won't hurt the cap orings any as they seem to be fine with petroleum based getting to them. The castor goes through the engine and all it's seals so cap orings should be fine as well. The little soft one at the top seams like silicone but I don't think it is as I have never seen fuel/oil...

If you have any capacity to the tank your going to want shut off valves

Steve, I can get the ZippKit collet tool made up and flywheel puller I have ready. Please send the $56 to [email protected] Send me your address too please. Thank you.

Ken, I can make you one right up for the fine thread Zipp Kit collet. They have been fine thread for about 5 years now. Originally, they were a different coarser thread. $34 shipped. Paypal is [email protected] Thank you, Daniel

Al has the 6002 as well I think.

Thinned enough to spray it would not be nearly as good as 2 part epoxy paint would be. Thinned enough to spray it may not have any strength if it even dries properly. Then since you still have to paint epoxy you would still have that step to go anyhow.

Rick, I just sent you Ronnie's address.

Rick, Just sent it to you. Check your inbox..

No new parts/engines at Gizmo, Fads or Prestwich in years. Almost nothing interchanges freely so you can't put other parts in them. 29.6 crank with straight ends to run in four bearings, 35 mm piston and ring pretty specific to the engine.

The 6201 12 X 32 X 10 is also used at both ends of the crank on Zenoah G320PUM engines.

I do them all the time. Buy them and have them sent here. They will be machined perfectly and forwarded on to you next day. You want them dead flat and true running. I have a arbor that threads in the front pawl side of them to chuck in lathe. A lathe is the tool you want to use to do the job...

Steve, Yes sir it will, very easily.

Joe, No sir. I am sorry only selling them complete.

Have one made and ready to ship. Starter 75/150C pack and charge cable. $385 shipped. Paypal is [email protected] This is the actual starter you will receive. Really nice and READY to SHIP

Yes sir these are rugged packs that should hold up well.

The pack has way more than you can put through the discharge lead. These aren't main motor packs for ESC. The pack is 25/50C but that rating is not too relevant when you put a 20 gauge discharge lead on them for receiver use. That wire becomes the C limiter. I don't think 20 gauge would...

I have LiFe 1800 receiver packs. These are IN STOCK NOW !!! They are 3 1/2" long 1 3/8" wide and 5/8" thick which is a great size for so many radio box installations 3 for $75 shipped Paypal is [email protected] The picture distorts the size and shape badly. I can't get a picture to...

John, I just sold 30 cubes last week but am out of stock on them. More coming soon. The LiFe transmitter packs have been so frustrating as the manufacture is putting proper part number on a battery that is not the right one. Working on that now but it could be a bit before I have a resolve and...

Take two lines from rudder fittings and Y them together and go into the pump. Where you pull pulse from is important. You want to go right into the bore of the intake NOT the carb pulse passage nor the crankcase. The pulse in the intake BORE is incredible makes lots of difference at low...

I have them but I do not sell orange silicone. The quality brown Vitons seal so much better and last considerably longer. I have brown Vitons in stock. Only 19 left. 10 for $15 shipped -or- 19 for $24 shipped