Search results

Bryan, may be show us a picture of your intende set-up? This way we can advice. The general going type as Mario and Emil posted is a T or Y connector, one leg to the bag, one leg to the carb and one leg with a short piece of capped tube to refuel and degas. But I've also seen version with just a...

Not to steal what Roman has, but one get to see more and more integrated propshaft with drive dog.. The shaft is 8 mm ( what we typically use in Europe, with a 1/4 inch 6.35mm portion for the prop.. Here's an example...

Great initiative Al. Though I'm not into methanol engines, any impulse and new stuff in a time where others stop, is good!

This looks like the Bob Finn brackets: he had them for sale in early 2019, might still have them. *edit* I was just made aware Bob Finn has recently passed away. Not sure who took over his shop, if anyone

Though I'm no expert in this Troy, I would make 4 alligning pins.. Using my 2 cents I would think that a 30 ton press would clamp the two halves together so the cable would not be over the dimensions of the die. My square inserts are a little over (5.09 mm or so, so a perfect 5 mm square would...

This subforum also cover these questions: most recent I think someone asled for Allison engine... https://www.intlwaters.com/forums/sport-scale-hydro-forum.10/

And another one: can't recall which prop, but after 2 tanks I started leaning out the H needle that really revved things up. (sorry for the tilt after several seconds...)

Happy camper here as the work paid out. Best prop in the end an ABC 2916, video is with a 2716 (could not film each outing). This run (on video) first run of boat and engine: too much steering making it to turn too agressive. Anyhow a good start. For turnfin I used a backlash one, which made the...

Good luck Shane: must be a beast to fine tune, but when it does..................................................................

Ready to run...

It's tiny as the measurements state: 3D model size: X 10.8 × Y 17.4 × Z 8.22 mm So 0.4 by 0.7 by 0.32 inch.. More a model of a model... Smaller then the old cox engines used for line flying

Whahoe triplets?

Assault, razor would get my 2 votes

With the pioneer engines in the Whiplash and Backlash I usually ran an ABC 2716-2 / 20. With rigger I think I need less rake to increase lift at the rear. Will report!

Which class: superstock?

Will do William: hope you get to see it run next year in Poland if you decide to go to the World Championship..

I like the WT257 better: it's easy 1 on the H needle and 2 1/4 on the low... As it is a stocker you don't need the larger intake area of a 1048

Boat is finished. Only when all was installed did I realize the the hood is a bit of a tight fit. So had to do some tricks make it fit: Cut the carby needles so they are not too wide, ignition wire tied to the cilinder and then the throttle control. In the end decided to use bicylcle spokes and...

Good healing!

I use a simple Hobby King electric pump on a 2 s LiFePo pack (stuck to it). The battery pack used are old receiver packs I no longer use after a season or 2 and still do ok, but I better be safe than sorry. Interestingly a 1600mAh pack can pump about 6 gallons before needing a small charge. In...