Search results

anything "Venom" failed with a large.. O-BOY!...lol

we tested a host of lipo bags.. the ones with the snaps did the best.. the Velcro units would come undone IF they did not use Kevlar stitching.

your good.. its about the best you can do do protect the battery's during transport. When it comes to storage, I have a 12g cabinet. It stays in the garage.. I am hoping it buys me time if and when the darn things decide to start a party...

Ammo cans.. I transport them in AMMO cans to keep from damaging them....this has LITTEL to do with my safety. We did some testing years ago with different "typical" containment units.. The ammo can was the gnarlyest.. when the battery went up (we forced this) the cans cover was ejected and...

in the end this is just Marketing, maybe they are paying a small fee to be able to yak about this. Grim

Bill, Here is what I know.. (Its FE.. your info will vary) You WANT to charge them AS CLOSE as you can to use. The less sitting the better. Then.. after use put them into storage voltage as soon as you can. Mine come off the charge and go into the model and get used. Now.. practical says...

And to add.. get those antennas AS FAR above the water as you can. The further away from the surface of the water the better! Grim

not together but to a parallel support along the keelson. I building fixture would be really nice for this.

you are going to want to fixture the tips of those sponsons before you sheet them or they will point out.

THAT BOAT LOOKS BAD ASS! Grim

Likely.. I have bought it at IRCHA as well as the Rapid Prototyping show in Detroit. They do get around. DARN GOOD STUFF!

Chris, Stuff looks good.. I have and do use Tech-Bond https://tbbonding.com/ NOTE: you can glue Silicone using Tech-Bond... and by gully.. it really does it. LOL But might give that a try too.. Grim

we have two of them here at work.. Grim

Thanks walster!

I will check mine when I get home

Get well soon Al!

I dont have a choice.. titebond is nice as the parts do not slip as much. Grim

big challenge between It staying on -and- removing it Grim

another view

I designed these sheet hold downs for my laser cutter. Work a charm.. 3D printed in ABS with a laser cut graduation on them. Just place though the honeycomb select sheet thickness and lock.. Grim