Search results

That is a very nice piece of equiment and well worth the price.

The needle bearings are the same size as in CMB, MAC and Kalistratove 67, 80, and 90 size engines.

Yes, I'll have a few pounds of bearings with me.

For almost 50 years I have been running Nitro boats. During that time, I used severl different brands of good bearings. Those made in Singapore, Swedish made SKF and Swiss made WIB bearings were the ones I liked the best. Jim Allen convinced me to use only Swiss Made WIB bearings. But those...

Does it have your name on it?

I am selling my Sears Craftsman drill press. It comes with a vise. This is a heavy drill press that stands on the floor. The price is $150.00. You come get it. You load it into your vehicle. You take it away. I will show you where it is at and then I will get out of the way.

Attached are photos of my EMCO FB-2 Mill. It comes with a large floor staqnd, a set of collets and a vedry nice vise. The price is $3000.00. You come get it. You load it in your vehicle. You haul it away. It is heavy. I will open the door, show you where it is at, and then I will get out...

Most of the people on this forum know of the term "end play". But, a lot of people on this forum don't really know what end play is and why it is a subject at all. Basically, aluminum and steel expand differently as the engine heats up. We are talking about a very small amount in one of our...

Those used bearings look good for more than 4 gallons of fuel.

The big bearing is a snug fit on the crankshaft. Not so tight that you have to drive it on, but you can feel it is tight, not loose at all. This in itself will reduce the endplay a bit. I noticed that when Jim Allen was assembling the Nelson engines, he would drive the big bearings into place...

My macine is an ENCO, not EMCO. Huge difference in quality and price.

I'm happy to bring some engines to Atlanta. I have sent you a message.

They come with standard, adequate bearings. If you are going to run hard, racing, time trials, I'd suggest you install the best bearings. If you run for fun now and then the bearings in the engine will last quite a while if you take care of the engine. A ten degree header is another $30.00...

I will have engines and headers with me in Atlanta.

Have you tried Speedmaster?

Yes the K21 engines are coming with collets for .150 cables.

You have to be careful as not all lubricants are compatible.

Not all the news is hunky-dory. Some of the recent engines have a few small problems. 1. The standard head button does not allow the standard glow plug to reach the combustion chamber. I have notified the manufacturer to make the change and asked them to send me replacement head buttons. I...

I believe I've caught up with everyone who has ordered a K21. The last four engines ordered are either in the amil or ready to mail. Another box from Ukraine showed up today, so I should have an inventory on hand from now on. My sincere thanks to everyone for the support they have shown the...

In a 5 gallon jug, 384 ounces Nitro 102 ounces Klotz Super Techniplate 154 ounces Methanol This is not so easy to measure the components. So, I mix in 5 gallon lots. That means as I switch from one gallon jug to the next, the fuel stays the same.