Search results

What your missing is that both pictures show the same thing. Only showing six of the eight you listed. I think you meant to post 2 different photos. One with 6 and the other with 2.

What ever you want Frank. These were set up for offset center rails. Individual rubbers. Gave him 2 size rubbers to choose from. Plus lots of spacers. He was not sure on sizing. If you can draw it, I will be probably able to build it. Looking for something special. Thats where my niche is. One...

Just finished up 2 sets of twin mounts for big blocks. Ready to ship out to one of my customers.

I still flush with WD40. I dont spin them over with starter because it can wear out the fit. I just hand turn it over to flush out the bearings. Do this twice with engine flooded. Then lube with rislone.

PM sent for payment details. Mike

Joe, How does 35 plus 8 for shipping sound?

If he dont. I believe I do. Never ran it.

Not yet Lohring. That will rack up in the kitchen wall area on the door. Not the tool box.

Tool boxes in action at the 2024 NAMBA Nats. Loving them.

Belly pan that motor. Then you can lower the shaft centerline. This will help with getting rid of some of the S bend. Mike

That looks to be an old short stroke 4 port to me. I have not seen one of those since the mid 90s. My old bearing chart says 607 and 2513 for those. Mike

Give Bridget a hug from me. Miss you guys.

I use a certain set of harden allens. I have 4 each standard and metric. These need the space on the sides to run the allen down into them. They drop in from the top. You can see them in the pic. My drawer are not removable by sliding them out. There is keepers built into the sides that stop...

It came in at 5lbs. I think the plastic one I was using is about 2 lbs. It does all the things I want it to do. I am not sure where all of you are hauling your tool boxes to. Goes from bench to trailer, then to pit table. All of about 30 ft total. If I cant haul it that far then it is time to...

You get twice as much water to cool with. Some motors have options to cool the head with 2in/2out. I personally just run one line to the motor and tap that for the exhaust header. 26 thru 30s. My BZM had a ton of ways to cool it. My twin gets one for each motor. Mike

Planning to build a wrench index in the bottom right drawer. Right now all the wrenches are jsut tossed in there. Might not get that done before I go.

Drawer front slides back into box to get out of the way. It is held in place with 2 pins that index into the top of the drawer cover. Spring loaded. Drawers can almost full pull out minus 1/2". There is a stop that keeps them from coming all the way out. Waxed up the rails and my slight binding...

All done. Both of them. Just in time for nats. Mark Anderson's tool box. He still needs to customize his for his Allen T handles.

Hopping is usually caused by the strut setup. Not trim tab. The surfacing props we run these day are happy with the bottom of hub basically riding at the water level. If strut is too high prop will drive the boat out of the water. As the boat drives it self out of water, the prop comes out. No...