Search results

Even with my touch up gun I don’t have the fluid adjustment opened all the way.Its very easy to get a run on the boats.The corners you have to be careful as they get painted from two angles.I use to always clear my boats twice the first go around then wait for a couple days wet sand the boat...

So Adam has this eagle sg it’s 41 inch long tub.Supposedly **** Jones had this boat built to his specs.Im going to rebuild it she’s in rough shape.Looks like when it was first built had two rear ride pads.Then there’s a center shoe added as it’s in wood grain and out ride pads are painted.Its...

Sold to Mike

Mike make it 90

Three still have seals on them the 4 one seal is missing but still full.80 plus shipping

The medium clear sets good 5 to 10 on first coat then do the wet coats first wet coat then by the time you clear all parts go ahead and do the second coat

A hour is a lot of time but you could do a small mix do your test panel and small pieces try 5 ounces mixed.

The ugly duckling isn’t ugly no more!Turned out very nice as usual.When you get ready to clear first coat I don’t make real wet more like a tach coat let it get sticky then two full wet coats don’t hurry take your time with the cooler weather you will have plenty of time plus hopefully no bugs.I...

This boat was a mess the epoxy never cured right was gummy they didn’t paint the boat but has been run.The sponson had the brass tube broke off so they glued the sponson to the rod.When I tried the remove the sponsons from tub ended up pulling 3 of the 4 brass tubes out of sponsons plus it...

Those engines fit tight like a tiger!They look small in there.Do you use a header with like 100 degree or a wrap to center type of pipe?With the carbs tucked to the sides do you use a cable or linkage pushrods?It’s a awesom looking cat!Just need to plan everything setting it up.Are you planning...

Nice clean setup.Only thing I didn’t like is the steering servo I would upgrade to at least a stronger servo.

Very nice I like the small piece of carpet for building on top of

Never thought about making them I may buy a stick of delrin and machine some on my lathe

Those are nice a thin where did you get them?I didn’t realize the blue on you slingshot is almost the same color as mine.

Adam had a zipkitts 12 rigger In bad shape so I’m in the process of going tru it I stripped the old epoxy off it was never painted but ran and wasn’t sealed properly not sure who built it.I ran out of the gen tech clear I have been using but liked the acme clear better.Tacks up fast and doesn’t...

Rich did you buy the Fc 720 clear?I was busy last month at work and was having a hard time going to the auto paint store so I bought the acme FC 720 clear with medium hardner and was very pleased with it.I bought it of Amazon.

1/4 inch jobber bit I believe 9/32 tube then a 5/16 tube that slides in to the 11/32 stuffing tube that gets hulled to the hull

Get as much of the hardware radio box servos fuel tank and mount mock up the hull don’t mount any thing and see where you balance point is once you figure that out then start mounting the motor.I make a wood wedge under the stuffing tube it is a straight piece I use a jobber drill bit in the...

Dog gone primer always shows the little imperfections.Looks real nice how did you like your new gun?

What kinda belt is it if it slips the battery should be good unless it slows way down.