Search results

The zenoah appears to be the older 23 cc with big plug

Easy to make thanks for the reply.

So do you put a needle in the y fitting and screw it in or out for the flow?

Here’s the eagle sg 21 from 2001 the paint has been in the basement on the top shelf found it two weeks ago I was happy it turned out I started on the lids and was happy

Temp was good today windy but doable.Want this project done.I found some old Imron paint from my daughters 20 eagle medium blue matches Adam ram truck he really like the color so I painted the sponsons cowl radio and bait box lids.Painted the tub orange.Hard to believe the date code on imron was...

Thanks for the reply’s Buckshot you say to regulate flow at rudder do you restrict the water nipple?

I always thought it should around 12

Wasn’t easy I thought I was done rebuilding for the winter then Adam shows up with this project being **** Jones old boat I wanted it nice and the right way was to gut it and strip it custom mounts for speedmaster hardware milled and mounted the engine strip the hull rebuild stuffing box new...

I too like hard tanks

Looking good! you using a hard tank or bag?

Looks like some orange peal going on but at least it’s painted!The klasskote can be sanded and repainted if the orange peal bothers you.

Found the grommets same size as a ceiling fan blade grommet.Stripped the boat needs a final sanding before I epoxy seal it.filled a few imperfections with wood putty.Adam ordered some cowls from Phil Thomas.Fitted it to the tub but was a 1/4 short in the tongue in front so I glued a 1/4 strip of...

Need pipe lenght for cmb black quiet pipe and drill hole size for water jacket going to plug the outlet and use a drilled hole for water exit of a eagle sg rigger

It’s ringed the only gas cmb I have run so far had one in my seaducer ran 73 mph before it blew off the water and had plenty more power to run faster

Yes 27 engine

Thanks for looking those must be for a 21 boat

Sounds good next few days going to aircraft strip the paint off.Got the hardware out of the hull had a hell of time getting the strut and drive shaft tube out of stuffing box.The hull must of had a drum style motor then later on had a disk motor the stuffing box was extended and soldered along...

Timbo here’s what I got tub side wall thickness is 1/4 inch hole size in tub is 13/32 but there’s paint in the holes bolt size is 1/4 inch I found one new grommet the middle outside measured. About .425 that’s where it fits into the hole if you don’t have them no big deal as I found one new one...

Thanks will take a look for them

Does anyone know the size of the rubber grommets for the engine bolts these are totally worn out.