Search results

Here’s the same thing but this was a dunked engine

Very well said everything has gone up

I would take a straight edge on the bottom of hull run trim tabs flat then strut try 3/8 up from bottom flat also get a stock 275 prop balance and sharpen it try it the motor is turning good rpm’s so the new pipe might help but there’s other problems the strut water pickup needs to go it a...

That’s a tight fit inside radiobox I’m not a fan of the flex throttle dealing with those small set screws isn’t for me.I like the standard rod setup but that’s me with quick release ball link.No tools needed to pull throttle apart when pulling engine.Looks like a nice build.

I sold my fun boat with the fly sky gt3c radio I’m using my 44seaducer for my new fun boat wanted another radio so I bought a fly sky gp7 for the seaducer.Wanted something cheap to have at the camp site.It has telemetry and is easier to setup the my last fly sky.I really like this radio even has...

Back the low needle out so it’s flowing like it’s not there then run the engine once you get it to run being rich you can set the low to idle you may have to open the throttle to keep it running throttling it up as needed.In the past when I ran nitro I never used the low speed needle cutting it...

Normal you can see how the burn is flowing

Post a picture of your strut and prop that rooster is really high needs some adjusting and possible a different prop

What prop you running ?

5463k54 I believe is what your looking for there in black or white

Are they saying you have to post on vendors forum?

I have a old accu cycle from hobbico if interested sell cheap

Have you tried soldering it?

I had a 27 in a mono ran 73 before it blew off the river and was still picking up speed

On small pipes I have use a lady foot pry bar that I clamp in a vise with the taper point straight up grease the taper part heat the pipe I used welding gloves and twist it on the taper once I get it to fit header I find a deep well socket that’s the same diameter and finish the fit with it...

This tool is a bit of over kill does work very little pressure needed have to be careful will split the pipe

Been over a year ago I talked to him.I know he likes Patrick Mahomes he posted the other day about the 67 disk gold head.Last year he said work has him real busy.Have you tried to call him?

I like the piece behind the pulley makes it stand up straight nice job

So I bought a fly sky g7p radio for a fun boat.On the bind setting it gives you the frequency setting for servos.What are you setting this too for digital servos?I was told to try 333 mhz any input on this setting?

Those old disk motors in the right hands can scream and will run with the pack.Woods rc use to modify them square bore the carb and rework the disk clearance and timing.I remember when tidewater was blowing them out the door for 175.00 those were the days!