Search results

Sold to Stephen !!!

Stephen, Hope all is well, I can do this for $210.00 total.

Nice CMB 67, clean and smooth, check the pictures. Castor stain as my fuel contains castor oil blended in. No major faults. $250.00 shipped in flat rate padded in the US. Others actual cost.

Both for the 400 Bruce, switching to PM

yours for the 400 Bruce, switching to PM

Nice CMB 67 with dual plug head button, some castor brown staining, no gouges or cuts, has venturi carb, no collet, smooth engine. $215.00 including padded flat rate shipping.

RCMK rear exhaust outrigger hydro, never wrecked, hardly run, needs your receiver, batteries, and prop. No bad habits, just have too many. $1200 plus shipping, will take apart for much tighter box. Boat is posted on other sites also.

A .67 CMB engine with a single plug head button, no gouges or hot spots, smooth engine, includes 1/4 collet. Check the pics. $210.00 including padded flat rate ride.

Beautiful Al, bring one down in November so we can drool.

Was Hy Tech Boats and HiTec boats the same company ?

Sold to Frank !!!!!! Thanks !!

Nice Picco .67 motor, check out the pics, no hot spots, no scratches, very smooth motor, looks like a little castor residue in second picture, offered as pictured, $225.00 plus the ride. Possible trade partially against a CMB Gold Head Beta .21 direct drive rotor and housing.

Sold

It is yours Frank, I should have asked my question in a separate thread.

Take your time, even Krylon rattle cans can be made to look good used slow and steady. Any regular spray paint needs 6 to 10 days to fully gas and cure, then again, slow and steady, use 2K clear two part rattle can urethane for the decal sealing glass smooth and shiny finish you desire, I have...

Not to steal the thread but Hey Frank, I know a guy with a used P/S that will slip right in !!!!! Glad you grabbed this before I spent money I shouldn't.

Tim & Frank, Tim was first, you know the drill. Must bore you guys with a question. When I set this up, Jr. grabbed a spare motor for me before I got spare parts for the box from Stu. It is equally clean and sharp but the drum is almost 180 degrees off and slightly larger diameter. He was told...

You got it Ronnie !!! Switching to PM

Here is a very low mileage CMB gold head Beta .21 Plenty pictures, no chopping inside, nice motor, nice and shiny inside. $300.00 check the pics.

I have no need for this piston/sleeve, Picco .67, almost the last of my Picco stuff, hopefully, motor follows after I open her up for a once over. This is a new p/s, never run, no packaging, I do not know the part number. Thanks for looking. $90.00 plus the ride and fees.