Search results

What type of axles on the trailer; torsion or leaf? Also, what's the inside look like? Please PM with pics and details on the buildout. Email at jthibodeau89@gmail.

It looks like it might be a Seaducer....

That looks like one that CMDI had CMB make for them several years ago. There was an error made on the muffler stinger. Like they made the stinger size on the OD instead of the ID. I picked up 2 from Andy for a song. You need to replace the stinger with the correct size and it will work great.

Pics sent via text. Sorry to take so long. Hull was in my storage unit.

I have an older Rico 20 as well. Red. Bare hull. $100 shipped USA.

Once you determine the length required for your setup, ideally you should weld up a specific pipe. But then you would need a different pipe for every site and weather condition. Kinda like NASCAR teams do with headers. Do some research and you will understand the principle behind sonic...

Yes, I have them in stock Please see my Post in the MFG/Distributors Forsale Forum for current pricing and other information. http://www.intlwaters.com/index.php?showtopic=34307&st=0 Thank you for your interest Jon

I have become aware of the possibility of some 6002 and 6002A bearings that I have sold might not be genuine WIB. The suspect bearings were labelled as Swiss Manufacture, but did not have WIB engraving applied. When I received these bearings from my distributor, I immediately called them to...

Yes, what Rick said. That said, the 45HR big bearing is the same as the .90~1.01 RS motors.

One thing to note, the expansion of the flow should start slowly, and then accelerate. I.E. use a smaller angle at first, and then, once the flow starts expanding, you can increase the angle. Otherwise there is a risk of flow separation and the pipe actually becomes a cylinder instead of a cone...

As I said, I'll take the package.

I'll take the package if the motors have not been cut on. Both motors are 21DD, correct? PM me for payment details.

Sorry Mark, my post generated a flood of requests. I'm sold out. I'll look for any loose packages I might have. Jon

It is the #4216 (L) that I was told was discontinued. I'll check back with Central on Monday. Thanks Terry.

Also need to be aware of any grind burrs at the center. They will make them appear off center, but once the burr is removed, they are fine.

I think that you'll find that Central doesn't carry them any more. They advised me on my last stocking order that they had been discontinued by Tettra. They said that they filled my order with all that they had available.I still have a few left. But once they're gone, they're gone. I will...

That Henkel blade is not a full wedge. The wedge break line at mid chord may be causing a flow separation that in turn causes the instability.

I also don't see how this is possible The R of the counterweight and the distance the corner is away from the wrist pin would meant that the skirt area in line with the wrist pin is 2-3mm below the arc of the CW. It is easier to draw. That is a bunch of crank flex....... Piston rocking at BDC?

Not near hard enough or wedge shaped.