Search results

Hi Fellas, I recently purchased the new Spektrum DSM system and installed it in a JR R1 radio for use in 3 Seaducer boats. All aerials have been installed at 8.5" in length (from the Rx case)with the maximum vertical rise possible. Range testing on land appeared OK but range in the water seems...

Good choice Craig. Justbe sure that you get the steering set-up correct (servo selection etc) and use the hole nearest to the centre on the steering servo out put arm. Best of luck.

Hi Guys, Thanks for all of your input on this topic. I have been able to contact Jerry C and with his help the boat now appears to drive quite well. After sending photos to JC he suggested that I move the rudder pushrod to the inside hole on the servo arm (as many of you did), remove any...

Guys, An update on progress with the Seaducer 45. Did more testing at the weekend and tried the following; 1) replaced 3 blade (X450x3) with X452x2 - no improvement. 2) replaced HS 605 MG with HS 645 MG (both running on 6 volts) - no improvement. 3) replaced 1100 mAh Ni-Mh battery with Ni...

Thanks Gents/Ladies, In response to your questions I purchased the boat from Jerry C complete with hardware at the NAMBA nats. I have attempted to contacted him with these problems but he does not return from holidays until 18 Sept. I have raised the strut in steps but this appears to make the...

Hi Guys, Recently built a new Seaducer 45 (SD3). All dimensions exactly as per instructions and running on X450x3 blade prop. Boats runs very wet and "hooks" badly both left and right. Have tried shortening rudder by 1" but only made it worse. Any ideas?